[DSP-10] Testing KDSP10/DSPx

Fri, 19 Sep 2003 11:26:47 -0500

You follow the test procedures in the KDSP10 building instructions.
Basically, you check the voltage from the regulator and see if one of the
led's blinks on power-on (can't remember which one without the instructions
sheet in front of me).

----- Original Message ----- 
From: "Tan Teik Chuan" <[email protected]>
To: <[email protected]>
Sent: Friday, September 19, 2003 4:20 AM
Subject: [DSP-10] Testing KDSP10/DSPx

> Hi Mike,
>
> Let me tell you my situation. I've bought DSP-10 kit from tapr. I started
> off with soldering the KDSP10 first. I wanted to test the KDSP10 board and
> maybe do some DSP experiment with it first, before going to solder the
main
> DSP-10 board.
>
> Are you meant that the sign-on message actually comes from the main board?
> Then, how can I verify whether my KDSP10 board is functioning?
>
>
> Regards,
> Teik Chuan
>
> _________________________________________________________________
> Download ringtones, logos and picture messages from MSN Malaysia
> http://www.msn.com.my/mobile/ringtones/default.asp
>
> _______________________________________________
> DSP-10 mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/dsp-10
>