[DSP-10] EZ-LITE and DSP-10 software

[Bob Larkin]

Hi Stan,

As usual I am short of time, but I wanted to let you know that I was going
to get you an answer. I am on my way to the airport, so it will be abreviated!

The .CFG file will be created at shut down of the DSP-10. But it needs
"hardware 0" to get shut down. A short text file

UHFACFG2
hardware 0

for UHFA.CFG should solve that problem, but I have not tested it. When I get
back I will try it, put something on the web page and note it on the DSP-10
reflector.

Hope this helps!!
73,
Bob


At 03:27 PM 9/23/02 -0500, you wrote:
>I am still about as green as it comes, but I am beginning to understand just
>a little of what I am reading on this subject.
>
>I am going to get the EZ-Lite running with the DSP-10  hardware config as 0.
>I have not been able to locate the .cfg file to make the change from
>hardware 1 to 0 but still looking.   I looked for a file that started out as
>UHF and end with .cfg ????    Maybe the .cfg is generated after I load the
>program ?  Anyhow I could not find it in the unzip ver 2.02.   I was able to
>locate a copy of Borland V 4.0 software on e-bay.
>Now I am at the dangerous stage, SO........
>
>It appears that the input mic stages on the EZ-LITE are by-passed and not
>used by the DSP-10 circuit ??
>
>I am also assuming that when hardware is config as 0 that the EZ-LITE does
>not look for the SER EN1 or SER EN2, PTT, HDW RDY or PLL LOCK from the
>DSP-10 board ?  J101/P101 not required for just audio operation ?   And we
>do not need to tie anything high or low on this connector.   ?  Jury is
>still out on this.
>
>I do understand the power and RS-232 connections.  HI  and I am putting the
>EZ-LITE board inside a nice shield box.
>
>Any suggestions on the first time to bring up a EZ-LITE running DSP-10
>software without the DSP-10 hardware board appreciated.
>
>Thanks, Stan ak0b@swbell.net
>
>
>
>
>
>
>
>
>_______________________________________________
>DSP-10 mailing list
>DSP-10@mailman.qth.net
>http://mailman.qth.net/mailman/listinfo/dsp-10
>
>