[DSP-10] Jumper wires

[Lee Scott]

Hi John,

The black coax wire will be used later to make the connections from the PC 
board to the Coax connectors mounted on the Hammond box.  These wires are 
not part of the PC Board.

I also ran out of wire for the bottom jumpers and dug into my scrap box to 
find some solid Teflon coated 26AWG wire.  Once I started using that, I 
replaced all the other jumpers I had done with this new wire. I found there 
were too many places where the jumper wire insulation was melting past my 
expected quality.

Another point - I decided to put the jumper wires on after the rest of the 
board was completed. I think putting the wires on first gets in the way of 
assembling the components on the board.

Lee

At 11:35 AM 3/5/2002 -0500, you wrote:
>Gentlemen,
>
>I've been lurking in the background for a few weeks now, I have noticed
>that those of you who are active on this list are farther along than I
>am in building the dsp-10.  I'm building from the TAPR kit,  I'm
>finishing up step one, wires.  The coax went well, most of the first
>page of wires went  well, I only found one jumper with only one end
>labeled (I hope).  I have run out of wire, no problem, except I have a
>length of wire that I haven't found a use for.  and I have a length of
>Black cable which looks like a single conductor shielded, almost the
>same as the coax but black.  I also have two lengths of enameled wire
>which I'm sure will be wound on toroids soon.
>
>Do any of you have any guidance on this 'black' wire?
>
>Many thanks,
>
>73,
>
>John DeHart  K1VBM
>
>
>_______________________________________________
>DSP-10 mailing list
>DSP-10@mailman.qth.net
>http://mailman.qth.net/mailman/listinfo/dsp-10