[DSP-10] (no subject)

Thu, 25 Apr 2002 19:55:14 -0400

If I remember correctly, throw everything into the same directory.

PD

----- Original Message ----- 
From: "Luis Cupido" <[email protected]>
To: <[email protected]>
Sent: Thursday, April 25, 2002 6:21 PM
Subject: Re: [DSP-10] (no subject)

> two ideas...
> 
> 1
> Put both in the same directory,
> when it asks disk2 just hit enter.
> 
> 2
> if this fails, make virtual drive letters
> using the dos "subst" function.
> (needs lastdrive='z' on the config.sys)
> 
> example
> 
> subst j: c:\disk1
> subst k: c:\disk2
> j:
> 
> then install from drive j:
> when it asks disk2 tell it " k:"
> 
> or variatons on the theme....
> 
> I did it and it was so straight forward trick that I no
> longer remember which one I used :)
> 
> 73's de CT1DMK.
> 
> ----- Original Message ----- 
> From: <[email protected]>
> To: <[email protected]>
> Sent: Thursday, April 25, 2002 9:55 PM
> Subject: [DSP-10] (no subject)
> 
> 
> I am trying to install the 'Old DOS Tools' for the EZ KIT. I have 
> downloaded the two files DISK1 and DISK2. For some reason that I 
> cannot figure out, when I run setup in the DISK1 directory, after 
> extracting the two files into C:\DISK1 and C:\DISK2, everything 
> seems fine until it asks for DISK2. Regardless of what I do, the 
> file (ezkitapp.ex$) cannot be found, even though it is in the 
> DISK2 directory tree.
> 
> Any ideas??
> 
> Regards,
> Robert -- WB6HKA
> 
> --------------------------------------------------------------------
> mail2web - Check your email from the web at
> http://mail2web.com/ .
> 
> _______________________________________________
> DSP-10 mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/dsp-10
> 
> _______________________________________________
> DSP-10 mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/dsp-10
> 