[DSP-10] (no subject)

[Luis Cupido]

two ideas...

1
Put both in the same directory,
when it asks disk2 just hit enter.

2
if this fails, make virtual drive letters
using the dos "subst" function.
(needs lastdrive='z' on the config.sys)

example

subst j: c:\disk1
subst k: c:\disk2
j:

then install from drive j:
when it asks disk2 tell it " k:"

or variatons on the theme....

I did it and it was so straight forward trick that I no
longer remember which one I used :)

73's de CT1DMK.

----- Original Message ----- 
From: <robevw@jps.net>
To: <DSP-10@mailman.qth.net>
Sent: Thursday, April 25, 2002 9:55 PM
Subject: [DSP-10] (no subject)


I am trying to install the 'Old DOS Tools' for the EZ KIT. I have 
downloaded the two files DISK1 and DISK2. For some reason that I 
cannot figure out, when I run setup in the DISK1 directory, after 
extracting the two files into C:\DISK1 and C:\DISK2, everything 
seems fine until it asks for DISK2. Regardless of what I do, the 
file (ezkitapp.ex$) cannot be found, even though it is in the 
DISK2 directory tree.

Any ideas??

Regards,
Robert -- WB6HKA

--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .

_______________________________________________
DSP-10 mailing list
DSP-10@mailman.qth.net
http://mailman.qth.net/mailman/listinfo/dsp-10