[Drake] fuse

Mon, 10 Feb 2003 21:47:03 -0800

That's good to know Garey....tnx
Dave

-----Original Message-----
From: Garey Barrell [mailto:[email protected]] 
Sent: Monday, February 10, 2003 8:34 PM
To: David Harmon; 'n3drk'; 'drake'
Subject: Re: [Drake] fuse

It's pretty difficult to solder a piece of wire to a cartridge fuse
without melting either the fuse element or the solder in the end cap.

Much easier solution is to put a couple of inches of #30 wire in place
of the fuse.   #30 will "fuse" at right around 8 amps.  It doesn't
need to be a precision fuse, since any failure will almost certainly be
a short and all you want to do is have the "link" open up before the
filament wiring gets hot enough to melt the insulation.  In fact, almost
all filament fuse failures are caused by someone shorting the filament
line to ground while troubleshooting.

22 ga. hookup wire is usually 7 X 30 or seven strands of #30 wire.

73, Garey - K4OAH
Atlanta

----- Original Message -----
From: "David Harmon" <[email protected]>
To: "'n3drk'" <[email protected]>; "'drake'" <[email protected]>
Sent: Monday, February 10, 2003 10:50 PM
Subject: RE: [Drake] fuse

> Just solder a resistor lead on each end of a standard fuse.
>
> K6XYZ
>
> -----Original Message-----
> From: [email protected]
[mailto:[email protected]]
> On Behalf Of n3drk
> Sent: Monday, February 10, 2003 7:20 PM
> To: drake
> Subject: [Drake] fuse
>
>
> Where can one find a an 8 amp 125V axial lead fuse for the t4xb?
>
> john
>
> _______________________________________________
> Drake mailing list
> [email protected] http://mailman.qth.net/mailman/listinfo/drake
>
>
> _______________________________________________
> Drake mailing list
> [email protected] http://mailman.qth.net/mailman/listinfo/drake