[Collins] K4 repair?

Osamu Hazawa [email protected]
Mon, 1 Apr 2002 10:13:25 +0900


Hello All,

While I was cleaning the K4 contacts of the KWM2-A, I happened to
cut the magnet wire of the coil at the terminal.
Since the magnet wire is extremely fine, I cannot remove the coat
out of the wire with the method I usually use.

Question:
    1. What method do I take for removing the coat?
        Or should I bag it to avoid such a microscopic (crazy?) work and get
        a replacement?

    2. Where can I find a reasonable relay for K4?
        I found one at Allied Electronics but I think it's still expensive
(less
        than that of SSN, though).

Thanks in advance,

Osamu Hazawa