[CALV-AUXCOMM] Winlink email

[Jim Tetlow]

My computer is on and radio set, internet set, rms winlink is open, auto receive is set to retrieve messages every 30 minutes.

If you would like to practice before the Net tomorrow night.

Address an email to K3UGA, send as winlink message, check request read receipt, post to outbox.

Open session Packet Winlink, 

Select  a node station from  Channel Selection.

Set the following , Digipeater,  KA3POX-10 (your selection); via  K3CAL-1 or -10

Hit Start.

Should make connection and send all winlink messages in your outbox.

Remember to select a node -gateway station that is on 145.750 if you wish to digipeat  with K3UGA -1 or -10 ......and that you are on 145.750 too!

Have fun 

Sent from my iPad,
Best Regards, 73,
Jim Tetlow