[Boatanchors] 6060 or 8640

[GGLL]

	It will go above 512 MHz if the extra module is installed (option ?, a 
doubler).

Regards
Guillermo - LU8EYW.

mikea wrote:
> On Thu, Mar 13, 2008 at 10:20:12PM -0400, Harold Hairston wrote:
>> Hello, Guys;
>>
>> The only thing that I had noticed on my recently acquired 8640 is that the 
>> displayed frequency may fall below or above that indicated on the Band 
>> Switch. In checking this out, I am told that this is a designed advantage. 
>> For example, in the .5 to 2(?), position I can tune down to get 455KC. I 
>> haven't checked all the positions but this seems to be correct (Happily). I 
>> am especially please with mine.
>>
>> I am making special note of your comments, though, and saving them for 
>> future reference.
> 
> Mine goes down to about 445 kHz, and up to about 1100 MHz. My 
> understanding is that, while the specs are 500 kHz to 512 (or 1024) 
> MHz, the intent was to make the 8640B usable for aligning 455 kHz 
> IF strips. I don't mind it going higher than 1024 kHz, either. 
>