[Boatanchors] bulkhead panel?

[brian goldsmith]

-----Original Message-----
From: Donald Sanders

I just measured my patch panel and the holes for the SO 239 type bulkhead s
are 9/16" (1.7 cm) diameter and for the BNC bulkheads 11/16' (1.4 cm).
My 2 panels are aluminum rack panels 3.5 inches wide. 


*****  If indeed your panels are three and one half inches high (not
wide,the width should be nineteen inches),then they are non standard and
will not fit correctly vertically into a nineteen inch rack that has other
equipment mounted on it.The actual height for a standard 2RU panel is three
and fifteen thirty second inches,this allows one sixty fourth inch at the
top and bottom of the panel to allow clearance between adjacent panels.
See this URL for further information :-

http://www.sizes.com/units/rack_unit.htm


Brian Goldsmith.