[Azden] tone board wiring

Wed, 16 Jan 2002 22:22:43 -0500

Ok the tone board has the red wire coming from underneath like you said but
it is soldered to a pin to the left of where the tone board goes.Should
there be a wire going from that pin to the board + or does it not go to the
pin next to the board? Sorry for the confusion but I'm not to bright in this
area and I'm trying to learn. Another stupid question,Is there a way that I
can check to see its working? Will I hear a tone when I prees the mic or
will some on another radio I'm transmitting to?
Thanks for all your help
Rob
----- Original Message -----
From: <[email protected]>
To: <[email protected]>
Sent: Tuesday, January 15, 2002 7:10 PM
Subject: Re: [Azden] tone board wiring


> First, there should be three wires.  You are apparently missing the red
> one which is power.
>
> The tone module is a Communications Specialists SS-32.
>
> Hold or orient the tone module so that the DIP switch is in the lower
> right hand corner.  Just above the switch body, on the right side, is a
> terminal.  It is right beside a transistor (actually a voltage
> regulator).  This point is ground.  Next up on the right is a capacitor
> and just on the other side of the capacitor is another connection point.
> This is where the red wire goes.  It is 12 volts.
>
> On the top left corner of the tone board, is the third terminal.  This is
> the tone output and is the white wire.
>
> When the board is installed into the radio, there are two terminals right
> beside it to the edge of the main board.  These are power and ground.
> There is one with a red wire coming up from below.  This is the 12 volt
> point and it is switched by the front panel switch.  The 12 volt pin is
> labeled J406 (but it's not the J406 as shown on the schematic).  The one
> labeled J407 is the ground pin.
>
> Now, where to put the white wire.  As you look at the main board, with
> the front of the radio toward you, follow the left edge of the shielded
> box at the front toward the back of the set.  About 1/3 of the way back
> you will find C44x (something).  Just to the right and a little toward
> the rear is the "real" J406 (which I think is unlabeled).  This is where
> the white wire goes.
>
> Ed
> K1ZOK
>
> On Tue, 15 Jan 2002 18:14:24 -0500 "Rob Crandall" <[email protected]>
> writes:
> > I have a pcs-4000 with the tone board and the guy I got it from
> > wasn't sure
> > the slide on wires were in the right place. It has two wires going
> > to the
> > board,one black and one white. I see three possibe points they could
> > go
> > onto. Two of them are on the edge of the board just abobe the dip
> > switches.
> > Could someone send me a pic or a diagram on how this goes?
> > Thanks and 73
> >
> > KC8SSG
> >
> > _______________________________________________
> > Azden mailing list
> > [email protected]
> > http://mailman.qth.net/mailman/listinfo/azden
> >
> ________________________________________________________________
> GET INTERNET ACCESS FROM JUNO!
> Juno offers FREE or PREMIUM Internet access for less!
> Join Juno today!  For your FREE software, visit:
> http://dl.www.juno.com/get/web/.
> _______________________________________________
> Azden mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/azden
>