[ARC5] [External Sender] Resistor Excursions

[Richard Knoppow]

    While I generally agree with this it is often not true for 
resistors. If you measure a resistor in place it will measure either the 
correct value or less. If it measures higher its bad. Can sometimes save 
some time when trouble shooting. Caps are a different matter and 
generally have to be disconnected to get a valid meaurement.

On 4/19/2024 10:21 AM, Bill Henderson wrote:
> As a general note, it is always best to measure any component 
> (especially resistors) disconnected from circuit.
> 
> Simply disconnect one end before measuring.
> 
>   - Bill H / va3hwa


-- 
Richard Knoppow
Los Angeles
WB6KBL
SKCC 19998