[ARC5] [External Sender] Resistor Excursions

[Bill Henderson]

As a general note, it is always best to measure any component
(especially resistors) disconnected from circuit.

Simply disconnect one end before measuring.

 - Bill H / va3hwa



[image: Mailtrack]
<https://mailtrack.io?utm_source=gmail&utm_medium=signature&utm_campaign=signaturevirality11&>
Sender
notified by
Mailtrack
<https://mailtrack.io?utm_source=gmail&utm_medium=signature&utm_campaign=signaturevirality11&>
04/19/24,
01:20:12 PM

On Thu, Apr 18, 2024 at 6:19 PM <releazer at earthlink.net> wrote:

> I earlier reported that in the BC-348 I am working on I had found a 1 meg
> resistor with a value that had dropped into the low hundred thousands.  But
> after I removed it and replaced it with a modern 1 meg resistor I found
> that when out of the circuit the old resistor had a value of about 1.5
> meg.  So, I still have only experienced old resistors that have increased
> in resistance rather than decreased.
>
> Wayne
> WB5WSV
> ______________________________________________________________
> ARC5 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/arc5
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:ARC5 at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: https://www.qsl.net/donate.html
>

-- 
CONFIDENTIALITY NOTICE:  The information transmitted in this e-mail is 
intended only for the person to whom it is addressed and may contain 
confidential, personal and/or privileged material.  Any distribution, use 
or copying of this e-mail or the information it contains by anyone other 
than the intended recipient(s) is unauthorized.  If you are not the 
intended recipient and have received this communication in error, please 
notify the sender immediately and delete the message and any attachments 
from your system.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/arc5/attachments/20240419/46174fe8/attachment-0001.html>