[ARC5] A parts question for the group...

[Richard Knoppow]

    I have a TS-352B/U, uses the same test lead set, MX-1331/U 
pins are 0.08 inches. I have some cheap test leads from All 
Electronics, same size pins.

On 2/3/2018 8:46 AM, DSP3 wrote:
> The pin plugs are red and black, labelled MX-1906/U (red) and 
> MX-1907/U (black).  The cord set is MX-1331/U.  I use these test 
> lead sets for a myriad of MIL type testers.  If you decide to buy 
> a cord set, especially if they're in the sealed bag, make sure 
> they are pliable.  I've bought some that were literally 
> petrified.... Plugs are OK but the HV wire is unusable....
> 
> Jeep - K3HVG
> 
> 
> On 2/3/2018 10:52 AM, Craig wrote:
>>
>> Last hamfest, I picked up a nice little TS-297/U multimeter. 
>> Needs a bit of cleaning and airing out and set of leads. My 
>> question is, does anyone know off hand what diameter the pins 
>> for these would be? The book lists a couple of cord sets, but I 
>> haven't found anything on them yet.
>>
>> The book lists the following for cord sets for single leads:
>> CX-529/U
>> CX-1331/U
>>
>> Thanks for any help,
>> Craig Cantwell
>> KF5JOT


-- 
Richard Knoppow
1oldlens1 at ix.netcom.com
WB6KBL