[ARC5] A parts question for the group...

[DSP3]

The pin plugs are red and black, labelled MX-1906/U (red) and MX-1907/U 
(black).  The cord set is MX-1331/U.  I use these test lead sets for a 
myriad of MIL type testers.  If you decide to buy a cord set, especially 
if they're in the sealed bag, make sure they are pliable.  I've bought 
some that were literally petrified.... Plugs are OK but the HV wire is 
unusable....

Jeep - K3HVG


On 2/3/2018 10:52 AM, Craig wrote:
>
> Last hamfest, I picked up a nice little TS-297/U multimeter. Needs a 
> bit of cleaning and airing out and set of leads. My question is, does 
> anyone know off hand what diameter the pins for these would be? The 
> book lists a couple of cord sets, but I haven't found anything on them 
> yet.
>
> The book lists the following for cord sets for single leads:
> CX-529/U
> CX-1331/U
>
> Thanks for any help,
> Craig Cantwell
> KF5JOT
> ______________________________________________________________
> ARC5 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/arc5
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:ARC5 at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/arc5/attachments/20180203/aab577d4/attachment.html>