[ARC5] Volume control - ARA receiver

[WA5CAB at cs.com]

A connector can also be salvaged from a junker receiver chassis (all EXCEPT 
B-model SCR-274-N) by removing one of the connectors for the RF coil pack.  
If you need it to run B+ into the receiver, you will need to drill a hole 
in the center and install one mini-banana pin.

In a message dated 07/12/2016 12:42:16 PM Central Daylight Time, 
kgordon2006 at frontier.com writes: 
> That connector can be easily made with some of those "small" banana pins 
> mounted in an 
> epoxy based form. What one does is to insert the pins into the rear-panel 
> connector through 
> a thin piece of cardboard to prevent the epoxy filler from getting into 
> the receiver's 
> connector, then surround those pins with another bit of thin cardboard, 
> then fill that with the 
> epoxy filler, let it set, unplug the "new" "connector", then solder the 
> necessary wires to them. 
> Works a treat.
> 

Robert & Susan Downs - Houston
wa5cab dot com (Web Store)
MVPA 9480
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/arc5/attachments/20160712/0e01bbae/attachment.html>