[ARC5] Netting Switch - Part 2

[Mike Morrow]

I wrote:

> **All** high voltage supply to the transmitter is disconnected
> when the unit is not keyed, by K-52 in the modulator.

It should also be noted that the transmitter dynamotor runs only
when the transmitter is keyed, when in VOICE mode.  Thus K-52 is
not too important...there won't be any HV from the dynamotor.
But in CW or MCW mode, the transmitter dynamotor runs continuously,
even in receive.  K-52 interrupts all HV to the transmitter
until the transmitter is keyed.

> The USAAF liaison systems SCR-287-A and AN/ARC-8 have
> a MONITOR-NORMAL switch at the operating desk near the
> BC-348-* expressly to allow the BC-348-* to be netted
> with the BC-375-* or AN/ART-13*.

It may be of interest that this is a switch that is NOT on the
receiver or the transmitter.  It is an external toggle switch
typically mounted through the operating desk top near the BC-348-*,
usually near the right side of the BC-348-*.

Mike / KK5F