[ARC5] Dynamotors

[Clare Owens]

I just looked at the CCT-46145 broadcast band unit that I used on 12V
in 1960 or so.  All I did was plug in 6V tubes (6V6 for the 12A6) and
moved one LV dynamotor brush 90 degrees - gave around 160V as I
recall.  I am very glad I didn't make any receiver wiring changes and
also that I saved that receiver all these years...  Do the ARC-5 sets
require wiring changes to use 6V tubes?

73,

Clare  N2RJB

On Sat, Jun 21, 2008 at 7:23 PM, Mike Feher <n4fs at eozinc.com> wrote:
> I still have quite a few of the 12 volt dynamotors NOS with the 3 pin mounts
> that fit and work fine. Only thing is, the ARC-5 has to be modified for 12
> volts, or feed only 12 volts to the dynamotor via a large power resistor, or
> regulator. - Mike
>
>
>
> Mike B. Feher, N4FS
> 89 Arnold Blvd.
> Howell, NJ, 07731
> 732-886-5960
>
>
> -----Original Message-----
> From: arc5-bounces at mailman.qth.net [mailto:arc5-bounces at mailman.qth.net] On
> Behalf Of David
> Sent: Saturday, June 21, 2008 6:04 PM
> To: ARC5 at mailman.qth.net
> Subject: [ARC5] Dynamotors
>
> Can anyone tell where all the dynamotors for the command sets end up going.
> I have looked at dozens of them on ebay and they don't have the dynamotors.
> Thanks
>
> Dave   VA7DG
>
> _______________________________________________
> ARC5 mailing list
> ARC5 at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/arc5
>
> _______________________________________________
> ARC5 mailing list
> ARC5 at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/arc5
>