[Antennas] All You Ever Wanted To Know About A Hustler 5-BTV Vertical !

Thu, 27 Feb 2003 00:11:29 -0600

I'm with you, Dan and that bright red wire sounds great! I need to replace
my radial field this Spring and red wire for a change might look great. Of
course, in a couple of months the Bermuda will cover it but it will be nice
until then.

73/72, George
Amateur Radio W5YR -  the Yellow Rose of Texas
Fairview, TX 30 mi NE of Dallas in Collin county EM13QE
"In the 57th year and it just keeps getting better!"

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of W1GOR
Sent: Wednesday, February 26, 2003 8:39 PM
To: [email protected]
Subject: Re: [Antennas] All You Ever Wanted To Know About A Hustler
5-BTV Vertical !

Dan,

The installation instructions for the 4, 5, and 6-BTV antennas specify fully
insulated radials.   The best way to accomplish this, is to bury insulated
wire and seal the outer end.   Liquid insulation works very well.   I've got
a 6-BTV and installed 4 radials per band.  Each radial is made of insulated
14 AWG stranded wire.  I chose a bright red wire that will show up well
against the green grass...  Up here in Maine, frost heave occasionally
causes shallow-buried radials to creep to the surface during the spring
thaw.   So far, I've avoided running over the red radials with my ride-on
lawnmower...

73, Larry - W1GOR

----- Original Message -----
From: "Dan Richardson" <[email protected]>
To: "Don Schaefer" <[email protected]>; <    >
Sent: Wednesday, February 26, 2003 3:31 PM
Subject: Re: [Antennas] All You Ever Wanted To Know About A Hustler 5-BTV
Vertical !

> At 12:15 AM 2/26/2003 -0600, Don wrote:
> [snip]
>
> >You can make the 5-BTV work with the
> >minimum number listed in the installation instructions, but adding more
> >FULLY INSULATED radials will improve the bandwidth and radiation pattern.
> >Read the instructions and make sure to insulate the outer ends of each
> >radial wire.  Home Depot, Sears, Lowes, and most local hardware stores
sell
> >liquid tape, an insulating compound that is available in small cans with
an
> >applicator brush inside the cap.  When you make up your radials, simply
dip
> >the outer end in the insulating liquid and let it dry.
>
> [snip]
>
>
>
> Don,
>
> The majority of your suggestions seem right on the mark, however, there is
> one which I am wondering about. I don't understand in your statement above
> what is gained (antenna operation wise) by covering the radial wires with
> plastic like insulation material.
>
>
> Danny
> K6MHE
>
> No trees were destroyed in the sending of this message.
> However, a large number of electrons were terribly inconvenienced.
>
> - - -
>
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
> _______________________________________________
> Antennas mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/antennas

- - -

Your moderator for this list is:
Larry Wilson KE1HZ [email protected]
_______________________________________________
Antennas mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/antennas