[AMRadio] Re: Hammarlund questions...

[Bruce - KB6LWN]

Hi Jim,

I have same problem (I think) with my 110C (SN 844).
If I leave the AVC ON, I don't hear ANYthing when
SSB mode selected.  The only way I can hear SB is
to switch the AVC OFF, which is what the manual
says to do for that mode, but even then - the SB
signals are a lot weaker than I believe they
SHOULD be.

Btw, have you been able to get your 50 Mc band
aligned correctly ?  I've been fussing with it
for the last several months and can't seem to
get it clos, even when using the procedure out-
lined in the docs about tuning 50 KC off then
putting the cabinet on.  I'm thinking about
enlarging one or two of the perf holes in the
bottom in order to get a tuning tool in there
to adjust it while the case is ON.  Unless some-
one has a better idea.

And Jim...  Yes there IS a Hammarlund list.
I believe it's at the Tempe AZ site, but I'll
look it up for you and get it to you directly.

73 - Bruce

PS: You wouldn't happen to have an FM-60A manual would you ?


On Sat, 19 Jan 2002, Norcross, James wrote:

> HQ 110A has variation in BFO wiring as shown in the schematic I have.
> The receiver blocks if switched to AVC and is in CW/SSB mode. Very
> strong BFO signal seems to be the reason
> AVC maxes out and blocks reception. This is a later built HQ110A VHF
> model.
=20
> =FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=
=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=FF=C01=16=9D=8A=89=9A=8AX=A7=82X=AC=B4=03=11=
i=D8=A8=FEf=A2=96f=A7=FE=ABa=FEw=AD=86=DBi=FF=FF=E6j)fj=7F=EA=B6=1F=E7z=DF=
=E6j)fj=7F=E5=8A=CBb=9D=FA?jj=DA

Hey Jim...  What's THIS ^^^^^^^^^^^^^ ???