[1000mp] Not working on bands

[John Halkiadakis]

Hello,

Try tapping the PCB with a plastic end of a screwdriver and see if you can find the cold solder joint (i.e. if the receive comes back on 12/10m when you tap the area).

If you can find the approx area then reflow all the solder in the area.

I have a FT1000MP and mine needed a new rotary encoder for the MEM/CH and I also had to replace all the electrolytic capacitors on the switch-mode PSU. My main receiver was also 3db down on RX compared to the sub RX and it was a faulty roofing filter (aftermarket INRAD) - which I removed and put the radio back to standard.

73,
John VK3YP 

> On 2 Feb 2026, at 4:33 am, nittner via 1000mp <1000mp at mailman.qth.net> wrote:
> 
> When I had the 1000mp and had that problem, I found a cold solder joint on one of the small coils but I don't remember which one. Just open it up and poke around or use freeze good luck. N9RD Sent from my Galaxy
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:1000mp at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html