[1000mp] RX Ant during TX 12/08/19

[HA3LN]

Morris, George, Bill,

Thanks a lot for your response.
Good but I think the protector is a good idea. Will look it up.

73!
Csaba



On 2019-12-08 18:29, Enigma Traveler wrote:
> As I recall, when transmitting, all unused receive connectors / paths 
> are grounded.
> 73 from Bill WD8ARZ
> 
> -------- Forwarded Message --------
> Subject:     Re: [FT-1000MP] Auto transmit receive antenna function
> Date:     Tue, 17 May 2016 11:33:04 -0400
> From:     WD8ARZ wd8arz at ix.netcom.com [FT-1000MP] 
> <FT-1000MP at yahoogroups.com>
> Reply-To:     FT-1000MP at yahoogroups.com
> To:     FT-1000MP at yahoogroups.com
> 
> User operating manual on page 10 states:
> "RX - normally, the antenna connected to
> the ANT A or B jack is used for receive
> (and always used for transmit). When this
> switch is pressed (display indicator on),
> an antenna connected to the RX ANT is used
> during receive.
> 
> User manual can be downloaded from:
> http://www.va3cr.net/manuals/Material/Manual1000MP.htm
> 73 from Bill - WD8ARZ
> 
> On 12/8/2019 6:45 AM, HA3LN wrote:
>> Hi,
>> Can you please confirm that in case when the MP goes for transmitting 
>> the RX input is disconnected by the RL1001 relay?
>>
>> I'm trying to trace this back on the schematic but kinda crowded.
>> I would like to make sure I'm not going to burn the receiver if I use 
>> any RX antenna.
>>
>> Thanks in advance. 73! - Csaba  HA3LN / HG3N - http://ha3ln.hu/