[1000mp] FT-1000MP MARK -V frequency run away

[Hawkins]

Rod,

Mine did that and it turned out to be two capacitors on the board on the 
front panel.  I think that this may be a common problem.

Steve

On 5/5/14, 8:57 PM, Mike Schatzberg wrote:
> Check the rapid tuning ring (jog ring) around the tuning dial. Make sure it is not hung up and is operating as it should.
>
> 73,
>
> Mike
> W2AJI
>
> Sent from my iPhone
>
>> On May 5, 2014, at 7:40 PM, Rod via 1000mp <1000mp at mailman.qth.net> wrote:
>>
>> Setup:  microHam micro Keyer II to FT-1000MP MARK V
>>
>> After the rig heats up the frequency begins to shifting down without
>> control.  Turning rig off sometimes resets it, only to ultimately start  again.
>> Any ideas?
>>
>> 73
>>
>> Rod
>> ______________________________________________________________
>> 1000mp mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/1000mp
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:1000mp at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:1000mp at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>


-- 
Stephen Hawkins NG0G
ng0g at mchsi.com
73 49 111 01001001