[1000mp] 232 chip

[J. C. Mc Laughlin]

Dear K6OLY:
Here is a direct copy of a txt document I wrote to myself after a good deal of effort directed to a replacement for the 232 chip:
-----------
Used in FT-1000 MkV: MAX232CWE 16 pin surface mount "wide"
pins are 0.050 inches apart. package is between 0.291 & 0.299 inches wide.
16 pin DIP devices with the same pin-outs include: 0 c to 70 C
MAX243CPE
MAX232CPE
MAX3232ECPE able to survive ESD
unfortunately, DIP pin spacing seems to be 0.100 inches
resulting in about double the length of the surface mounted IC
Thus use of a DIP to S socket will not work.
What was purchased:
ADM202EARWZ improved over MAX3232E able to survive high voltages
ADM232LJRZ direct replacement
Z at end = no Pb
---------------------------
The original chip is too fragile and fails in the sort of environment common to the radio. Attachments are not possible or I would attach data sheet.
I also looked at optical isolators. People do sell “boxes” able to isolate the chip in radio from essentially every hazard. The chip has to be replaced. A socket would be nice, but a beefed-up chip is probably enough.
73, Mac N8TT

From: jmarshall1945 at yahoo.com 
Sent: Saturday, March 08, 2014 7:06 PM
Well, for some unknown reason, my CAT interface decided to quit... At first, I thought it was my logging software, then the cable interface, now after chasing the serial data pins on the interface, serial data is going in to the radio, but nada on the output. In fact, the SO pin (serial out) is at 0 volts potential, which is not a valid level for RS-232... 

After all the above, looks like I am going to have to find an RS-232 driver chip for my 1000mp. I know there have been other posts on this before, but wondered if anyone knows where I may get my paws on one of these drivers? (I haven't even looked up the part number yet!). Any info will be helpful.
Thanks in advance,
F. James Marshall, k6oly

J. C. Mc Laughlin
Michigan U.S.A.
Home: JCM at LenTel.Com