[1000mp] If the FP-29 dies

[Rob]

ed,


you should be able to use those two supplies; you would have to figure  
out how to wire them to the rear panel molex power connector but that  
should not be too difficult.    If you are concerned about this it  
might be a good idea to get a voltmeter and use it to see what  
voltages are where on the yaesu supply's pins at the end of the power  
cable, while your FP28 is working.   Make a pinout diagram, and file  
it away.  Then if you ever have to wire up an aftermarket supply, it  
will be a no-brainer.

73

rob / k5uj



On Jan 29, 2009, at 7:47 AM, Ed Hughes wrote:

> If my FP29 power supply for my FT1000MP MKV were to fail........ As I
> understand, the 2 voltages supplied are 30 vdc & 13.8 (12vdc). Could  
> I use a
> combination of
> say an Astron 30vdc 18amp & my Astron 12vdc & put the MP back on  
> line ? Or
> is there some other voltages etc involved ?
>
> Ed
> KG4W
>
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:1000mp at mailman.qth.net