[1000mp] Split operation?

[Jerry Spring]

Yes, you can do this by just reversing the RX and TX buttons on the top.  You may not want to do this, however, as there are some features that don't apply to receiver B.  Also, if you radio isn't equipped with two sets of filters, you may not be able to receive in certain settings on VFO B.  For example, I only have a CW filter 500 Hz for VFO A. When I listen to VFO B I must use the wider 2.0K filter since I don't have the 500 Hz filter for the second VFO.  

Hope this helps.

Jerry
VE6CNU


--- On Tue, 2/24/09, Brad Anbro <n9en at charter.net> wrote:

> From: Brad Anbro <n9en at charter.net>
> Subject: [1000mp] Split operation?
> To: "1000MP" <1000mp at mailman.qth.net>
> Received: Tuesday, February 24, 2009, 10:09 PM
> I have what is probably a "stupid question" in
> regards to
> the 1000MP; I've looked over my user's manual but
> did
> not see it discussed in the manual.
> 
> Is there a way of setting up the 1000MP for split operation
> so that "VFO A" can be used for transmitting and
> "VFO B"
> can be used for receiving (the opposite of what is normally
> used, as when trying to work a DX operation that is using
> split operation)?
> 
> I have an older 1000MP and was wondering about this.
> Thanks for any help with this.
> 
> 73 de Brad, N9EN  
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:1000mp at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list:
> http://www.qsl.net/donate.html


      __________________________________________________________________
Instant Messaging, free SMS, sharing photos and more... Try the new Yahoo! Canada Messenger at http://ca.beta.messenger.yahoo.com/