[1000mp] Mark-V Field receiver.......

[Bill Belt]

Lou,
Thanks for the response.  I haven't dug into the radio yet, but I think my
problem is similar to yours.  I really think it is a relay driver.  I am
going to dig in and see what I can find.  Thanks for the info.  I have also
checked the VE3CR website and all of the info seems to point in the same
general area.  I think I saw a note from you there also.  
Thanks again for the info.

Bill
W9WM
========================

-----Original Message-----
From: 1000mp-bounces at mailman.qth.net [mailto:1000mp-bounces at mailman.qth.net]
On Behalf Of Lou
Sent: Friday, August 17, 2007 10:38 AM
To: 'All about Yaesu 1000mp'
Subject: RE: [1000mp] Mark-V Field receiver.......

Sounds very similar to a problem I had with my MkV.  It turned out to be a
fet controlling a T/R relay very near the antenna connectors. On my
non-Field rig it was Q6451 driving relay RL6451 that was bad.  

Lou W7HV

-----Original Message-----
From: 1000mp-bounces at mailman.qth.net [mailto:1000mp-bounces at mailman.qth.net]
On Behalf Of Bill Belt
Sent: Thursday, August 16, 2007 6:12 PM
To: 'All about Yaesu 1000mp'
Subject: [1000mp] Mark-V Field receiver.......

My 2 year old Mark-V Field has failed me.  It takes a signal strength of S9
or S9 +10db for the station to rise above the noise and be able to copy.
This is as compared to a TS-940 on the same antenna.  This is consistent on
the main as well as the sub receiver, any band, any mode, all antenna
selections, and both antenna connectors.  I think I have tried every button
there is on the radio.  I have reset the microprocessor as well.   The
transmitter appears to load fine and produce full output power.  It has not
been intermittent at all.  Once it failed, it has been consistent.  

I have not dived into the radio yet.  I emailed ("no phone calls please")
WA4GEG on Tuesday, but have not had a response as yet.  I intend to take the
cover off and do the "Tap Tap Tap" thing on some of the relay's, etc., but
haven't done it yet.  

Anyone had a similar experience or ideas of the most probable area to dig
into?  I think I would prefer to not try to do any surface mount repairs on
a board.  I think I will leave that to someone with the proper equipment.  I
was hoping it might be a relay, since there seems to be a history of relay
problems, but most are intermittent type problems, or certain bands etc.  

Ideas or suggestions appreciated.

W9WM  ex K9DUF
Bill
Pittsfield, IL

______________________________________________________________
1000mp mailing list
Home: http://mailman.qth.net/mailman/listinfo/1000mp
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:1000mp at mailman.qth.net

______________________________________________________________
1000mp mailing list
Home: http://mailman.qth.net/mailman/listinfo/1000mp
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:1000mp at mailman.qth.net