[1000mp] Receive problem

[Uwe Egen]

Hi Dick
My first thinking is, in the past you switched to 20 on the second
input/output Ant A or Ant B. If you come back to 20 later on you set 
up the radio to last configuration out of the memory. Suppose this is 
the second antenna input/output. The LEDs show this situation.
Do not forget the second 20m memory position if you press the 20m
button again.
Hope this will be the reason and not a hardware failure.
73, Uwe, DL9NC



"Dick White" <whiter26 at sbcglobal.net> schrieb:
> I have a Mark-5 that I bought last September. I have had this problem for
> two days.
> 
> I have NO receive on 20 meters.  Not sure if I have TX.
> 
> I DO HAVE receive and TX, on all other bands.
> 
> When I punch in the button for 20 meters, there is almost no noise. When I
> go to another band I hear the usual noises. If I am on, say 15 meters and
> switch off the antenna, it sounds just like 20 meters does when the antenna
> switch is connected. I have tried CW, RTTY and PSK31 and have not copied a
> signal for two days. No CW, no RTTY no PSK31.
> 
> Any ideas to help me ?  Has anyone ever had this happen to them ?
> 
> 73 and thanks  Dick  KS0M
> 
> 
> Richard C. "Dick" White
> Fulton, MO. 65251  U.S.A.
> whiter26 at sbcglobal.net
> 
> Amateur Radio Station - KS0M
> 
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:1000mp at mailman.qth.net
> 
>