[1000mp] Power problem

[Andy]

Hi All,

After I worked with small power again  with my FT1000MKVField on WPX and PACC contest  I tried to test some menu's (specially 9.2). 
Before the start of change all tune was originals. I put the load 50Ohm/200W and start to change the level of IF TX Gain. 
All level for FM/AM is same in all bands but the problems with power on CW &SSB is still one..... after I change the all manufacturing tune a receive this results:

MENU 9.2 - TX IF Gain:

      BAND FM PWR AM PWR CW PWR SSB PWR 
      MHZ level watts level watts level watts level watts 
      1.8 5 100 7 100 max(15) 60 max(15) 65 
      3.5 4 100 6 100 max(15) 90 max(15) 100 
      7 4 100 6 100 12 100 12 100 
      10 4 100 5 100 11 100 11 100 
      14 4 100 6 100 13 100 13 100 
      18 4 100 6 100 14 100 13 100 
      21 4 100 6 100 11 100 11 100 
      24 4 100 6 100 max(15) 80 max(15) 90 
      28 4 100 7 100 max(15) 60 max(15) 60 
      29 4 100 6 100 max(15) 60 max(15) 60 


But I thinks that is not the right tune . Can be possible the problem is somewhere in IF board ??? or AF or CNTR??? .
I'm sure that the power amplifier board is work properly. 

Any ideas what could be going on?

How can be reload a new software ?

Best Regards,

Andy
LZ2HM
>Hello all,
>After I buy new FT-1000MP MKV Field the last year  and operating on few contest (CQWW CW,ARRL and some RTTY ...)  ....one morning the rig couldn't get more than 50W ( I=10A) output on SSB and CW . It was cold.... all night was turn off . The problem is somewhere before the last unit (Power Amplifier) and other ??? because on AM and FM modes radio give a full power 100W ( I=20A) . All voltage on reg unit is worked well. I made few restart of radio ( all possible) ..[29(0)]+POWER;        [SUB(CE)]+[ENT]+POWER;        [SUB(CE)]+[29(0)] +[ENT]+POWER; but nothing :((((
>I hope that is some small problem but I still not study all schematics .

>Any ideas what could be going on?
>73!
>de Andy LZ2HM
>one of  LZ9W Contest Team