[1000mp] Quick Split on Mark V

[Brian Smithson]

I just noticed something nice about this. You can engage split two ways:

If you have the quick-split enabled and press the red TX button on the sub
VFO, split is activated and the freq changes.

You can also press press the red TX button on the MAIN VFO. Split will be
engaged but the sub VFO will *not* change.

I accidentally discovered this and it solves a little annoyance I've found
where most of the time I want the quick-split except for those times that I
don't ;)

Enjoy!

-Brian n8wrl 

-----Original Message-----
From: Brian Smithson [mailto:n8wrl at att.net] 
Sent: Friday, February 11, 2005 3:14 PM
To: 'All about Yaesu 1000mp'
Subject: RE: [1000mp] Quick Split on Mark V


When you press the red TX button on the sub-vfo, that activates split &
applies the offset from that menu. Pretty slick!

-Brian n8wrl

-----Original Message-----
From: 1000mp-bounces at mailman.qth.net [mailto:1000mp-bounces at mailman.qth.net]
On Behalf Of n3drk
Sent: Friday, February 11, 2005 3:07 PM
To: 1000mp at mailman.qth.net
Subject: [1000mp] Quick Split on Mark V


Page 28 of the Technical Manual Mark V has the Quick Split Feature with menu
1-6 to set the amount of the split. Where on the front panel is the split
key? john



-----------------------------------------------------------------
If it isn't CW, then its CB!

73s
n3drk-john
-----------------------------------------------------------------

______________________________________________________________
1000mp mailing list
Home: http://mailman.qth.net/mailman/listinfo/1000mp
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:1000mp at mailman.qth.net