[1000mp] RE: QSK ?

[Tod - ID]

Thanks Bill, I will try that.

Tod
 

>-----Original Message-----
>From: 1000mp-bounces at mailman.qth.net 
>[mailto:1000mp-bounces at mailman.qth.net] On Behalf Of Bill
>Sent: Thursday, November 11, 2004 5:03 PM
>To: 'All about Yaesu 1000mp'
>Subject: RE: [1000mp] RE: QSK ?
>
>Tod,
>
>I use my FT1000MP all the time in "full-breakin" mode. I have 
>noticed the pop that you have described. It appears to be 
>worse when I am listening with the wide filters(ssb), the DSP 
>off and the Clarifier off. 
>
>I usually use my 1 K CW filters and EDSP on. This seems to 
>eliminate the popping most of the time. It also seems that you 
>can vary the "tone of the pops" with the clarifier.
>
>The settings on 7-1, 7-2, and 7-4 don't seem to have an effect 
>on my radio.
>They are set on 12, 36, 16 respectively for whatever that is worth.
>
>Try setting your EDSP Contour to "9 o'clock" and N R to "A" 
>and see if that has any effect. 
>
>Not too scientific, just an observation.
>
>Bill, W5VX
>
>>-----Original Message-----
>>From: 1000mp-bounces at mailman.qth.net [mailto:1000mp- 
>>bounces at mailman.qth.net] On Behalf Of Tod - ID
>>Sent: Wednesday, November 10, 2004 10:51 PM
>>To: 'All about Yaesu 1000mp'
>>Subject: [1000mp] RE: QSK ?
>>
>>Gary:
>>
>>I know you are a first class CW op so I am pleased to hear it 
>is not my 
>>imagination. My ICOM-756 ProII has much better QSK I am afraid.
>>
>>Les, KL7J sent me some ideas on adjustments to Menus 7-1, 7-2 
>and 7-4. 
>>I tried those but they did not solve 'my' problem.
>>
>>After trying those I changed to VOX controlled CW and no 
>keyer -- just 
>>a key closure. There is a very distinct "pop" as the receiver comes 
>>back on. I set the voice delay to be quite long and long after the 
>>keying has ended (a couple of seconds) the pop is heard. I am 
>guessing 
>>that it might be some pulse from an internal relay that is 
>getting into 
>>the audio chain when the transceiver switches from TX to RX.
>>
>>I am surprised that this has not surfaced in the reflector 
>stuff I have 
>>been reading since about 2000. Maybe it was discussed (and resolved I 
>>hope) at an earlier time.
>>
>>If anyone had any ideas I would certainly like to hear them  --- 
>>especially before I start tracing those very tiny schematic diagrams. 
>>After having installed the key click mod prior to ARRL SS CW 
>it was sad 
>>not to be able to really operate QSK without feeling I would 
>damage my 
>>ears. Many of the really good ops I worked were already sending stuff 
>>by the time the radio had switched back on when I allowed the 
>computer 
>>to control the TX-RX timing.
>>
>>
>>
>>I wonder if George, W2VJN, or Tom, K8JI, have dealt with this in 
>>FT1000's or FT1000MP's.
>>
>>Tod, KØTO
>>
>>
>>
>>
>>>-----Original Message-----
>>>From: 1000mp-bounces at mailman.qth.net
>>>[mailto:1000mp-bounces at mailman.qth.net] On Behalf Of Gary Ferdinand 
>>>W2CS
>>>Sent: Wednesday, November 10, 2004 6:32 PM
>>>To: All about Yaesu 1000mp
>>>Subject: RE: [1000mp] Is QSK with the MP or the MarkV possible?
>>>
>>>Welcome to the so-called QSK of the MP.  If you find a solution, I'm 
>>>all ears.  What you describe is what I hear, too.  It doesn't come 
>>>even close to the Kenwood TS930/40/50 series QSK.
>>>
>>>Gary W2CS
>>>
>>
>>_______________________________________________
>>1000mp mailing list
>>1000mp at mailman.qth.net
>>http://mailman.qth.net/mailman/listinfo/1000mp
>
>
>_______________________________________________
>1000mp mailing list
>1000mp at mailman.qth.net
>http://mailman.qth.net/mailman/listinfo/1000mp
>