[1000mp] RE: filter info please

[Hans Remeeus]

Hello Doron,

I have the 1000D and the Field. Both with Inrad filters.

INRAD filters are g-r-e-a-t!

Suggestions for CW:

2800 Hz
2100 Hz
1000 Hz
400 Hz

For SSB:

2800 Hz
1800 Hz

I exchanged the three standard Yaesu filters (also the two who are soldered)
by Inrad filters. To exchange the two soldered 8.2 MHz IF-filters needs some
experience...

The menu to choose the filters of the Field is quite simple:

- Press FAST and ENT together
- With VRF/MEM CH you go to menu 5-1
- You will see: oFF 8.2-2.0
- Turn Main VFO-A to the right untill you see that 'oFF' changes to 'on'
- do the same with menu 5-3, 5-5, 5-6, 5-7 or 5-8

Good luck!


73, Hans Remeeus.
Ham Radio: PA1HR
www.remeeus.nl

Communication is about people, the rest is technology.


----- Original Message -----
From: <DELSONCOMM at aol.com>
To: <1000mp at mailman.qth.net>
Sent: Tuesday, November 02, 2004 6:31 PM
Subject: [1000mp] RE: filter info please


> hello
> i am new to this group, however is any one can please help me on this
issue
> i had for many years the ft 1000d ,i now have the 1000 field
> i am looking to add filters
> so what the best to go for inrad or yaesu ?
> i see in the picture that the is 2 filter that need to take the all board
> out
> is this 2 filters can stay and i can add inrad or i cant mixd them
> the 2nd part i cant understand how to install in the program all this
filter
> is any one have a step by step information how to set them up
> the manual don't say much
> many thanks for any information
> Doron 4X1RG [Ron ] 73