[1000mp] Setting 1000MP for semi break in?

Mon, 26 Apr 2004 16:51:25 -0400

Per my Acrobat pdf file copy of the manual:

Keyer Delay - For "semi-break-in" (non-QSK) CW
operation, the switchover time delay from Tx to Rx can
be adjusted from 0 seconds (full break-in) to 5.10 seconds
(in 10-msec) using menu selection 7-5. Note that
this provides a separate "hang time" adjustment from
the "VOX Delay" setting used during voice operation.

Adjust the delay to what is comfortable for you.  Do you want it to drop =
out
between works or not until you are done keying?  Set the delay too long =
and
you miss some of the other station's TX.

73,

Art
W2NRA

Art Searle
Director of Finance/Treasurer
[email protected]
(631) 730-4084

-----Original Message-----
From: [email protected] [mailto:[email protected]] =
On
Behalf Of [email protected]
Sent: Monday, April 26, 2004 2:53 PM
To: [email protected]
Subject: [1000mp] Setting 1000MP for semi break in?

I've always run my 1000MP QSK. To put less stress on the linear when I =
use
it=20
I'd like to run semi qsk so the relay isn't constantly going.

To do this I believe you turn off break in and set the vox on ,on the
1000MP.=20
If that is correct my question is, where on the menu do I  adjust the cw =

delay time and what is a recommended time?

Thank you,

Gerry =20

[email protected]

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
_______________________________________________
List Moderator: Richard Lubash N1VXW
1000mp mailing list
[email protected]
To Change Options or Unsubscribe:
http://mailman.qth.net/mailman/listinfo/1000mp