[1000mp] MP Rcvr lost its zip

Wed, 08 Oct 2003 09:45:31 -0500

Do you get it with the DSP on?  Mine was doing that, and it turned out to be 
the DSP analog to digital board.

Bill k1xt

>From: "Bill" <[email protected]>
>Reply-To: [email protected]
>To: <[email protected]>
>Subject: [1000mp] MP Rcvr lost its zip
>Date: Tue, 7 Oct 2003 21:31:43 -0500
>
>I have noticed of late that there appears to be some kind of intermittent
>problem with my MP (purchased new in 1999). The problem has grown
>progressively worse with time and it doesn't seem to be intermittent
>anymore. The MP is not dead but signals and noise have dropped considerably
>on all bands.
>
>I looked back through the archives and noticed that a couple of similar
>problems have cropped up with others. Apparently the wire leading from the
>coax connector to a small board has caused a problem and the other report
>was a bad relay.
>
>I noticed that my case isn't quite the same as the others mentioned. I get
>the same effect using BOTH Rcvr antenna inputs (a & b), but apparently the
>sub-RCVR is NOT effected. Lots of signal using the sub-RCVR.
>
>I plan to open it up tomorrow and check it out.  Any suggestions before I
>start?
>
>Bill, W5VX
>
>
>_______________________________________________
>List Moderator: Richard Lubash N1VXW
>1000mp mailing list
>[email protected]
>To Change Options or Unsubscribe:
>http://mailman.qth.net/mailman/listinfo/1000mp

_________________________________________________________________
Get McAfee virus scanning and cleaning of incoming attachments.  Get Hotmail 
Extra Storage!   http://join.msn.com/?PAGE=features/es