[1000mp] Filters

Sat, 8 Nov 2003 18:35:33 +0100

Hello Tom,

The manual is quite clear about it, but it is always possible to put the
filter in the wrong socket.

You could check this very easily via the menu. Please active the filters
(actually the filtersockets) one-by-one in the menu and check whether you'll
get 500 Hz bandwidth at a certain setting. Then you know if you have put the
filter in another socket then the one which is ment for the 500 Hz filter.

Good luck!

73, Hans Remeeus.
Ham Radio: PA1HR
www.remeeus.nl

Communication is about people, the rest is technology.

----- Original Message -----
From: "Tom Fitzpatrick" <[email protected]>
To: <[email protected]>
Sent: Saturday, November 08, 2003 6:26 PM
Subject: [1000mp] Filters

> I recently installed a 250Hz 3nd IF filter (INRAD) and a 500Hz 2nd IF
filter
> in my FT-1000MP.  The 250Hz filter works fine, but when the 500HZ filter
is
> selected the receiver goes dead no matter what 3rd IF filter is selected.
I
> have actived the filters through the menu.  Is it possible I put the 500Hz
> filter in the wrong socket?  Any suggestions?
>     Tom, K4IE
>