[1000mp] Transverter Switch

[w3sz]

Hi, Terry,

I never mess with the transverter switch.

I just turn off the FT1000 MP PA using the menu item 8-3
when I am using the transverter.

No problems doing this for the past couple of years.

I use SSB Electronics transverters here, with a DEM 4 port
switch between the transverters (for 144, 432, 1296, and
2304) and the FT1000 MP Mk V.

FT-1000MP "TRV" goes to IF in, "RCV ant in" to IF out on the
transverters.

73,

Roger Rehr

> I recently built the DEM 50-28 Six meter transverter (with
> extra gain stage option) for use with my FT-1000MP.  My
> rig sits on a shelf at the operating desk in a manner that
> the little "Transverter" slide switch under the top hatch
> is not readily accessible. 
> Has anyone remoted their "Transverter" switch out of the
> 'MP to a more convenient location?  I hate to have to pull
> the rig out everytime I want to check on the activity on
> 6. 
> Perhaps there is another way to bypass the PA on this rig
> and get the low power drive out to the rear Transverter
> connector without using the slide switch and I have just
> overlooked it. 
> Any suggestions and assistance would be appreciated.
> 
> Thanks,
> 
> Terry, W=d8FM
> 
> 
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> 1000mp@mailman.qth.net
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp


73,
Roger Rehr
W3SZ
FN20ah
http://www.qsl.net/w3sz
--------------------------------------
   This EMail Was brought to you by
               WebMail
    A Netwin Web Based EMail Client
  http://netwinsite.com/webmail/tag.htm