[1000mp] New MARK-V

[Dennis]

Hi Lou,

 Well I might say I like you answer the best although most say to run with
out the "BK-IN" button pushed.  I have used my TS-2000 and my ICOM-775 full
QSK with the AL-1500 before and never had a problem and I'm sure it was one
of the features I look for before buying it, but can't seem to find that
information in print at this time.  To complicate matters just a bit I will
be adding the FTV-1000 50 MHz Transverter which should be here early this
week.  Looking in the MARK-V book I will be using the Band Data jack to
connect to the FTV-1000 to the MARK-V but I'm assuming there will be second
jack on the FTV-1000 for connection to the amp.

Thanks for your input,

Dennis AB8NI
----- Original Message -----
From: "lhlousek" <lhlousek@nvbell.net>
To: <1000mp@mailman.qth.net>
Sent: Sunday, March 16, 2003 3:58 PM
Subject: [1000mp] New MARK-V


> When you use the VOX button for CW you are operating semi break-in.  There
is a also break-in button next to the CW speed control (under the second VFO
knob) that allows full QSK operation.
>
> I'm running full QSK with an Ameritron amp that has the built in QSK-5
switch and use pin 2 of the Band Data jack for keying the amp and the TX
inhibit input (pin 8) to prevent the rig from transmitting if the amp is not
ready.  Works FB.
>
> Lou W7HV
>
>
> --- StripMime Report -- processed MIME parts ---
> multipart/alternative
>   text/plain (text body -- kept)
>   text/html
> The reason this message is shown is because the post was in HTML
> or had an attachment.  Attachments are not allowed.  To learn how
> to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> 1000mp@mailman.qth.net
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp
>