[1000mp] Q: RX antenna switch

Sun, 21 Dec 2003 22:33:06 -0800

I switched to the B jack as primary and, yes, the problem persists. It is
further down the line.

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Bill Barber
Sent: Sunday, December 21, 2003 11:37 AM
To: [email protected]
Subject: Re: [1000mp] Q: RX antenna switch

I have also had similar occasional problems on my 1000MP, but this has
happened on A antennas from time to time, without switching to the RX
antenna.  Every time it is cleared and signal levels restored by pressing
the mike PTT.  I have not checked to see if this follows to B antenna.

My Serial # is 7N250070, purchased in May 1998.

Bill, NE1B

----- Original Message -----
From: "Thomas Otterbein" <[email protected]>
To: <[email protected]>
Sent: Sunday, December 21, 2003 8:46 AM
Subject: [1000mp] Q: RX antenna switch

>
> Hi all,
>
> I have at the RX-ANT IN in a long wire receiving antenna.
> At the ANT A (Main Antenna) is a Groundplane connected.
>
> When I swith from the front panel via the Ant Switch RX
> to the longwire and than back to the ANT A the former
> receiving level from the main antenne A is strong decreased
> (like a ATT is switched).
> When I shortly push the Mic-PTT the receiving level is comming
> up of main antenna A to the former leven and all is ok.
>
> What could be the problem ?
> Some relays not switching ?
>
> Thanks for helping!
>
> Bye..
> Thomas, DG8FBV

_______________________________________________
List Moderator: Richard Lubash N1VXW
1000mp mailing list
[email protected]
To Change Options or Unsubscribe:
http://mailman.qth.net/mailman/listinfo/1000mp