[1000mp] Packet and RTTY jacks

Thu, 14 Aug 2003 13:24:55 +0200

Hi John, maybe this is the solution for you, I don`t use PACKET&RTTY ports
but DVS2&RTTY. Here is the complete(rtty keying, ptt keying, cw keying)
solution dedicated to ft1000 series...  I use it with my MP Field....
http://users.volja.net/s57ndt/
p.s. sry for bad scanned scheme

73 de Ted S57NDT
----- Original Message ----- 
From: "John Passaneau" <[email protected]>
To: <[email protected]>
Sent: Thursday, August 14, 2003 4:43 AM
Subject: Re: [1000mp] Packet and RTTY jacks

> Hi:
> I have a Mark V field and I wanted to use it on PSK/RTTY with the normal
> sound cards programs and be able to use my narrow filters on those modes.
It
> seemed like the way to do this was to hook up to the Packet jack with
audio
> in/out and PTT. Then run USB and use the normal PSK/RTTY sound card
> software.  It does not work because it seems the TX audio input is not
> active in that jack except when the PKT button is pushed. And of course
none
> of the user modes that can be set with menu 8-6 is a USB mode. The easy
set
> mode seems to think that your going to tune in a PSK signal by tuning the
> radio instead of pointing and clicking on a waterfall display or what ever
> your software uses. The answer I found is to use the user set menu to fake
> the radio into thinking its on USB.
> The setting I used are:
> Mode- PAC-lo (packet lower sideband)
> DSP-ofst- 0.000 (display offset, puts the display to show the suppressed
> carrier frequency)
> R-Pll- 1.450
> R-car- 453.550
> t-Pll- 1.500
> t-car- 453.500
> rtty-sft- 0.000
>
> These are the setting that are used in a normal USB mode selected by the
USB
> button.
> So with the user-set menu setup, to use PSK/RTTY with my sound card
> software, I tune would tune my rig to 14.070MHz and push the PKT button
and
> hold it until the LED flashes, signifying I'm in the USER-SET mode. The
LSB
> LED is lit but I'm really in USB which you can verify by tuning in a
station
> on USB and pushing and holding the PKT button until it flashes and you
will
> be able to copy just fine.
> In this mode I also have the use of all my narrow filters, the speech
> processor is shut off for me so I don't need to remember to do it and the
TX
> audio is enabled and I'm as happy as a clam.
> I use Digapan and TrueTTY and they work just fine. I worked TZ6RD in Mali
on
> RTTY with this setup on split today so it works just fine for my way of
> operating. My interface is a home brew thing with transformer isolation
and
> adjustable pads to set levels.  I set my mic. gain to the best spot for
> normal SSB operation and then in the PKT mode adjust the levels from the
> computer for proper operation on the digital modes without changing the
mic.
> gain. This make changing from SSB to digital a almost one button
operation.
>
>
> John Passaneau W3JXP
> State College, Pa
> [email protected]
>
> ----- Original Message ----- 
> From: "William P Osborne" <[email protected]>
> To: <[email protected]>
> Sent: Wednesday, August 13, 2003 8:54 PM
> Subject: Re: [1000mp] Packet and RTTY jacks
>
>
> > PTT  parallel in all modes  and data out provides auio at 30mv in all
> > modes. But data in does not function in other than Pkt/Rtty.  I am in
> > the middle of trying to decide how to configure all of this so I ahve
> > been testing and this is what I think I found.
> >
> > 73 Bill, K5ZQ
> >
> > William P Osborne
> > Dean School of Computing and Engineering
> > University of Missouri-Kansas City
> > 816-235-2399
> > [email protected]
> >
> >
> > ----- Original Message ----- 
> > From: "Ron Kenwood" <[email protected]>
> > To: <[email protected]>
> > Sent: Wednesday, August 13, 2003 7:04 PM
> > Subject: [1000mp] Packet and RTTY jacks
> >
> >
> > > Before I start building interfaces, can anyone tell me if the PTT
> > and Data
> > > Out lines are active full time on both or only when the respective
> > buttons
> > > are pushed.
> > >
> > > Thanks. Ron, W3ZV
> > >
> > > _______________________________________________
> > > List Moderator: Richard Lubash N1VXW
> > > 1000mp mailing list
> > > [email protected]
> > > To Change Options or Unsubscribe:
> > > http://mailman.qth.net/mailman/listinfo/1000mp
> > >
> >
> > _______________________________________________
> > List Moderator: Richard Lubash N1VXW
> > 1000mp mailing list
> > [email protected]
> > To Change Options or Unsubscribe:
> > http://mailman.qth.net/mailman/listinfo/1000mp
> >
>
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> [email protected]
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp
>