[1000mp] What 2 look 4 when buying a used 1000

Wed, 16 Oct 2002 22:09:49 +0200

Hello Yuri,

How is your Front End switched? Don't use IPO on the bands >14 MHz.

When there is noticeable less band noise on one of the bands you don't have
to worry much. I have this for example on 7 MHz, but the rig is not less
sensitive on this band (on the contrary). It could be a factory adjustment.

Of course it could be the antenna too.

When there is noticeable more band noise, then something may wrong. Perhaps
with one (or more) of the FET's or there is a wrong adjustment somewhere. I
had this on a FT-990.

Hard to give a 100% advise, I must admit.

73!
Hans Remeeus.

Ham Radio:
PA1HR

Sites:
www.remeeus.nl
www.qsl.net/pa1hr

e-mail:
[email protected]

----- Original Message -----
From: "Yuri Onipko" <[email protected]>
To: <[email protected]>
Sent: Wednesday, October 16, 2002 9:55 PM
Subject: Re: [1000mp] What 2 look 4 when buying a used 1000

> Hi Hans
>
> > Take your time to listen on all the amateur bands; do you notice any
> > differences between the bands or noticeable receiver noise? Use the
Front
> > End switch for this purpose.
> >
>
> What if band noise on one of the amatuer bands (21 MHz) is weaker than on
> others?
>
> Thanks.
> Yuri  VE3DZ
>
>
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> [email protected]
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp
>