[1000mp] FT 1000 MP seems to be off 0,1 Khz on TX ?

[1000mp@mailman.qth.net]

Bill, K0ZL wrote:

"I think this would be a master oscillator alignment issue... where is
the master oscillator on the 1000MP?  I don't have my service manual yet.
 Should just be an easy tweak..."
==========
Although adjusting the master oscillator won't correct a 100 Hz tx/rx
offset, it will correct any frequency error the VFO readout has.

The access to the adjustment is through the small hole on the master
oscillator unit (see page 99 of the FT-1000MP oparating manual).  The
adjustment is there for all three master reference oscillators available
for the MP, i.e., the stock REF-UNIT, the TCXO-4, and the TCXO-6.

Adjustment is needed if WWV's frequency as displayed on your VFO readout
is not what it should be when the signal is zero beat in the LSB or USB
mode.

73, de Earl, K6SE