[1000mp] Can't adjust FT1000mp vox delay

Tue, 1 Jan 2002 08:25:37 +0100

Hello William,

This is a setting in the menu.

Please enter the menu and go to 7-5. The default is 0.00 seconds (full
break-in). Set it e.g. to 0.30 or whatever delay you like, untill 5.1
seconds.

Also check menu 7-4.

Good luck and enjoy your MP!

Kind Regards,
Hans Remeeus PA1HR.

e-mail: [email protected]
site: www.remeeus.nl
Ham Radio call: PA1HR
Tel.: +31 172 586600
Fax: +31 172 587013

----- Original Message -----
From: "William Hein, AA6TT" <[email protected]>
To: <[email protected]>
Sent: Tuesday, January 01, 2002 2:33 AM
Subject: [1000mp] Can't adjust FT1000mp vox delay

> I purchased a FT1000mp years ago just I had to take a break from ham radio
due to work commitments.  Sat in the box for several years and just
yesterday pulled out and set up.
>
> I cannot get the VOX Delay adjusted.  No matter where I set the DLAY pot
on the ALC unit, the rig seems to be in full break-in mode.  And, yes, I
made sure the BRK-IN switch is off.
>
> My FT1000mp is the DC version, serial no. 5F010078, with all the Yaesu
accessory filters and TCXO-6 installed.  I also installed the IR background
noise & AGC mods and cut the J68808 Line 2 wire for transverter operation
per the manual (the rig is intended to be used as a full-time 6m IF).
>
> Suggestions?  Hate to send in for repair a rig I haven't even used yet!
>
> 73 & HNY,
> Bill AA6TT
>
> ------------------------------
> William H. Hein, AA6TT
> 10 Clark Road
> Topsham VT 05076-3086 USA
> tel 802/584-4317
> -------------------------------
> http://www.AA6TT.com
> email [email protected]
> MSN IM [email protected]
> -------------------------------
> _______________________________________________
> 1000mp mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/1000mp
>