[1000mp] No TX

[Clair Yeagle]

I had the same thing happen to my rig Tom. Luckily it was still under
warranty. Yaesu replaced  a pair of M37702M8B-307FP ICs and the rig has been
fine for about 6 months. I hear factory service is getting better, you might
try that if it is still under warranty.
Good luck with it.
73 Clair N3CY
----- Original Message -----
From: "Tom Horton" <k5iid@ntelos.net>
To: <1000mp@mailman.qth.net>
Sent: Saturday, December 14, 2002 2:29 PM
Subject: [1000mp] No TX


> Well, I planned on operating the 10 meter contest.
> After 50+ Q's the transmitter quit.
>
>   I was switching antennas and all of a sudden the rig went into
> transmit at full power and I could not get it out of that mode without
> turning the power off.
>   After turning it back on, I could not get the rig ro key. In a moment or
two,
> it did th esame thing og going into transmit on it's own. I watch the
> power and reduced the transmit power manually and at zero watts out,
> it was still keyed.
>   Turned the rig off again, did a master reset, and still no keying the
rig...
> key, vox,ptt, foot switch, all nada!
> The rig receives normally.
> Has anyone seen this phenomenon?
> Suggestions? Any good MP repairmen on the East Coast?
> Have I done something stupid?
> 73, Tom K5IID
>
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> 1000mp@mailman.qth.net
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp
>