[1000mp] RX Ant Out

Wed, 11 Dec 2002 19:37:36 -0600

and a preamp?????

----- Original Message ----- 
From: "Bill Gode, Sr." <[email protected]>
To: <[email protected]>
Sent: Wednesday, December 11, 2002 7:21 PM
Subject: Re: [1000mp] RX Ant Out

> Barry,
>
> Check out the MP schematic diagrams.  On the RF Unit, relay RL1001
> normally connects the receive antenna line (RX RF), coming from the T/R
> relay (RL6016 on the LPF Unit), directly to the MP's receiver.
>
> When RL1001 is actuated by pressing the RX ANT button, it breaks the RX
> RF line and routes it "out" the RX OUT jack and "in" the RX IN jack.
> You could connect bandpass filters, an external receiver, a receive-only
> antenna, a VHF receiving converter, or any other appropriate accessory
> to one, or both, of these jacks.
>
> 73,
>
> Bill, W9NHQ
>
>
> Barry N1EU wrote:
>
> > I'm still trying to make sense of this and appreciate W9NHQ's input.  I
> > just found just a hint of information on p41 of the tech overview.
> >
> > I think the received signal coming off the xmit antenna is routed to RX
> > ANT OUT and you can put in external filtering/loop it back into RX ANT
> > IN or feed it to a second receiver.
> >
> > Thanks & 73,
> > Barry N1EU
> >
>
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> [email protected]
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp
>
>