[1000mp] RX Ant Out

[Bill Gode, Sr.]

Barry,

Check out the MP schematic diagrams.  On the RF Unit, relay RL1001 
normally connects the receive antenna line (RX RF), coming from the T/R 
relay (RL6016 on the LPF Unit), directly to the MP's receiver.

When RL1001 is actuated by pressing the RX ANT button, it breaks the RX 
RF line and routes it "out" the RX OUT jack and "in" the RX IN jack. 
You could connect bandpass filters, an external receiver, a receive-only 
antenna, a VHF receiving converter, or any other appropriate accessory 
to one, or both, of these jacks.

73,

Bill, W9NHQ


Barry N1EU wrote:

> I'm still trying to make sense of this and appreciate W9NHQ's input.  I 
> just found just a hint of information on p41 of the tech overview.
> 
> I think the received signal coming off the xmit antenna is routed to RX 
> ANT OUT and you can put in external filtering/loop it back into RX ANT 
> IN or feed it to a second receiver.
> 
> Thanks & 73,
> Barry N1EU
>