[Yaesu] FT-8100 control head

[KB0NLY]

I went down that road about five years ago, spent almost a year chasing a 
good control head, problem is every control head I found had issues as well. 
What I eventually did was painstakingly solder jumper wires from the 
controls to various points on the boards to fix all the connections, that 
fixed it, and then I promptly sold it due to the anger I had for that 
radio!!

The 8100 is a good radio, but the control head is absolute garbage because 
of the controls.  The little connector that the two sub-boards with the 
controls mounted on is the issue, if you jumper past that its fine, but it 
takes really tiny wires, a really fine tip iron, and some magnification to 
do it.  I think I spent about three hours fixing that blessed thing.

73,

Scott KB0NLY


-----Original Message----- 
From: Tom WA9WSJ via Yaesu
Sent: Saturday, February 03, 2018 4:35 PM
To: Yaesu Reflector
Subject: [Yaesu] FT-8100 control head

Hello Gents,
Does anyone have a good FT-8100 control head that you're willing to part 
with?
The one I have has volume/squelch control failures on both bands.
Diagnosing proved to be bad/broken connections to the pc board. Very 
difficult to fix!
Rather replace it.
Thanks,
Tom wa9wsj
______________________________________________________________
Yaesu mailing list
Home: http://mailman.qth.net/mailman/listinfo/yaesu
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Yaesu at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html 


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus