[Yaesu] Yaesu Repair Facility at Cypress, CA

[N8NN]

Adam -- Your advice was right on the money.  The switch needed
to be turned "off".  I was concerned to see the error message, especially
after the amp had just arrived from repair; but now things are working
normally.

Thanks for your help.

Bert N8NN


----- Original Message ----- 
From: "Adam Farson" <farson at shaw.ca>
To: "'N8NN'" <n8nn at comcast.net>
Sent: Tuesday, October 17, 2006 2:40 AM
Subject: RE: [Yaesu] Yaesu Repair Facility at Cypress, CA


> Hi Bert,
>
> Message #1005 can result if the REMOTE switch on the rear panel of the
> Quadra RF Unit is ON (up), and the amplifier is not connected to a Yaesu
> exciter which supports remote power control.
>
> If the #1005 occurred when no exciter was connected, try changing the
> switch
> to OFF (down). If the #1005 still occurs, there is a problem in the PSU.
>
> If you saw the #1005 with a compatible exciter (FT-1000MP, MkV etc.)
> connected, there may be a fault in the exciter or the Band Data cable.
> Again, try turning the REMOTE switch OFF (down).
>
> I have an 8-year-old Quadra which has never missed a beat. The exciter is
> an
> IC-756Pro3, so the REMOTE switch is down.
>
> Cheers for now, 73,
> Adam VA7OJ/AB4OJ
>