[Yaesu] FL-7000

[Kelley]

I just connected my FL-7000 to my FT-1000D with the bandswitch cable, ALC
cable, etc., and followed the startup instructions in the manual. It tuned
up just fine on 20m, a local ham thought it sounded good.

I then went down to 160m and tried it there. The antennas SWR was a little
high, so I thought I give the tuner a try. I did as the manual said, pushed
in the TUNER button, hit the MOX on the FT-1000D, and hit the START button
on the amp. The amp worked on that for a while (I had heard this can take a
bit the first time) and then came back with the READY light on.

Great, so I thought. Ever since then the amp will not put out any power at
all. Even if I go back to 20m, nothing. The amp keys, but no power. At no
point did the WARNING or PROTECT lights come on. Both FAN lights did
however.

Any ideas on what I did wrong??

Kelley - W�RK