[Yaesu] re tble with FT-1000D

[van lincoln]

This has always been 'my nightmare' !!!!

good luck!

wd8aam

At 11:09 AM 1/19/2004 -0800, Fern Rivard wrote:
>Has anyone had the misfortune of feeding 100 watts of rf into the FT-1000D
transceiver? Symptons are as follows:
>1) no rf output due to open coils L7218 and L7219 in swr protection
circuit of the LPF board which causes a total shut down of the transmitter.
>2) Poor receive sensitivity to both receivers due to again on LPF board
RL-7218 burnt open the normally closed contacts that go to the receiver
>3) Receiver sensitivity is ok on both receivers if going directly to their
inputs but no s-meter readings on the main receiver?
>    Would like to correspond with anyone who has experience in dealing
with similar problem.
>    Thanks from Fern
>
>
>
>--- StripMime Report -- processed MIME parts ---
>multipart/alternative
>  text/plain (text body -- kept)
>  text/html
>The reason this message is shown is because the post was in HTML
>or had an attachment.  Attachments are not allowed.  To learn how
>to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
>
>Moderator: Ray Brown, KB=D8STN
>_______________________________________________
>Yaesu mailing list
>Yaesu@mailman.qth.net
>http://mailman.qth.net/mailman/listinfo/yaesu
>