[Yaesu] 1000MP

Wed, 10 Sep 2003 07:11:03 +0200

Dear Arnaud,

Here is your solution:

---
Preset the RF PWR control fully clockwise, and tune the transceiver to
14.2000 MHz. Select CW mode, key the transmitter and adjust VR3003 for 100
Watts on the meter.

You will find VR3003 on the AF Unit.

VR3007 = 50W & 10W RF Power Output
VR3006 = 50W & 10W RF Power Output
VR3003 = Overcurrent ALC Maximum RF Power Output
VR3002 = 50W & 10W RF Power Output
---

If you have any further questions, just send an e-mail to this reflector.

Good luck and 73!
Hans Remeeus.
Ham Radio: PA1HR
www.remeeus.nl

Communication is about people, the rest is technology.

----- Original Message -----
From: "F0DPT Arnaud" <[email protected]>
To: <[email protected]>
Sent: Wednesday, September 10, 2003 2:49 AM
Subject: [Yaesu] 1000MP

> Hello
>
> I have one 1000MP, that I bought second-hand but the power is of 135w
> Approximately, who knows the procedure of reglage to put back the100w of
> origin?
> Thank you
>
> 73's
>
>
>
>
>
> Moderator: Ray Brown, KB�STN
> _______________________________________________
> Yaesu mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/yaesu